Cable Support - Tenlog D3 Pro

thingiverse

Remixed from https://www.thingiverse.com/thing:4399211 **NOTE: This support may interfere with extruder movement when printing tall objects. (Above Z 330 on my printer.) ** After printing the original I found it difficult to snap onto the extrusion without breaking. Upon further inspection I realized that my cables were long enough to pass over the top support so I decided to remix the original file into that configuration. I used a couple of M4 bolts and a T-nut to hold everything in place. The front bolt passes through the clip and support and into the T-nut. The rear bolt passes through the clip and makes it's own threads in the support to secure the cables in place. The stiffening of the underside is a bit beefier than I originally intended but I thought if I was going to have to use material to support the area I might as well put it to use. Being new to 3D printing I printed this with supports under the 20mm gap. It may very well be possible to print the whole part without supports. I printed the main support at .2 mm layer height and the clips at .1