Cable Holder for Micro Swiss NG

thingiverse

DescriptionThis is a cable holder bracket that attaches directly to any Micro Swiss NG (Revo or standard) direct drive extruder and is securely held in place using only one M3 6mm screw.This bracket prevents the wires that connect to the various parts of the extruder and hot end from constantly being tugged on as the printer is printing and should increase the life of the wiring.This design can be quickly printed and then mounted in seconds. The design is much easier to mount than the other designs I have come across and is a good option if you want to mount your cable in the positon shown in the pictures.Note that there are other designs around on the internet so try searching "Micro Swiss NG Cable mount" to assess if this is the right choice for you. Installation StepsThread a cable tie through the holes in the top channel. It should thread through by itself but you can observe it through the channel.Attach the bracket using a M3 6mm screw (length is important although this is a pretty standard size and length as far as 3D printer screws go).Position the cable and fasten the cable tie