Cable holder for MagSafe 3 2m cable

thingiverse

# Magsafe 3 (2m) cable holder The cable holder is designed to have two halves. The cable can be unwound from any side, which allows you to only unroll the cable as much as you need, on any side you need (charging brick or laptop). ## Usage 1. Assembly (see below) 2. Feed cable through: there is a cutout in the middle which gives just enough space to feed the USB-C end of the cable through. 3. Roll up the cable on either side (about half of the cable should be on either side) 4. Repeat step 3 until the magsafe end of the cable nicely fits into the cutout of the holder 5. You now have a cable you can unroll as needed! ## Requirements 1x Velcro cable tie a little super glue