Cable Guides for Soma Wolverine with Rohloff

thingiverse

These parts are for a Soma Wolverine bike frame using a Rohloff IGH and a Co-Motion shifter. The frame lacks the cable guides for the Rohloff shifter cables. My solution was to print parts that support the cables on the bottom of the downtube using the existing shifter bosses as well as the water bottle boss on the underside of the tube. I also add one cable support mid way down the downtube attached with a zip tie. There are two cable guides on the chain stay that keep the cables stacked so that they down interfere with wheel or crank. Note that you need to print two CableBossCapRP parts, one for each side. The GuideBottom part is held in place with these two cap parts. You also need two GuideBottleCageRP parts that screw into the water bottle bosses on the bottom. The GuideBeltStay parts are similar but not the same. One goes near the bottom bracket and the other goes about half way down the stay.The RP suffix is my way of noting these are the read to print version of the STL files as they have been oriented appropriately to print.