Cable duct for Micro Swiss direct drive

cults3d

I'm really enjoying my Micro Swiss direct drive mount. My Remix Direct Mount worked absolutely fine but my Wynsinn failed after being on and off one too many times, so I switched to this shiny one instead. The mount comes with a cable management bracket that is supposed to attach to the old extruder mount, but it doesn't come with anything to keep the wiring tidy around the e-stepper. To avoid any issues, you need to route the wiring loom up and over the stepper motor or it could interfere with the gantry frame. This solution works pretty well on its own, but for added stability, you can slip a zip-tie through the optional holes to secure it in place. There are also several small cable tie openings available, so use them all if you want or none at all - your choice!