Cable connector Wago 221-2411 with cable gland (M25 & M16)

prusaprinters

<p>Allows easy connection of up to 4-wire cables more conveniently and quickly via Wago 221-2411 lever terminal than with commercially available screw terminal variants. Strain relief and shielding against external influences is achieved by an M25 or M16 cable gland.</p><p>Print time on an SLA printer is 4-8 hours (standing without support, on small up to 8 pieces at a time: 30-80 minutes piece time) and uses about 12 ml of resin. On FDM printers, the threads may need to be recut (consider test pieces: nut/nuts). Besides the thread should not cause any problems on FDM printers, but so far it has only been printed on SLA printers.</p><p>&nbsp;</p><p>assembly instructions:</p><p>attach the smaller cable gland on one side<br>Feed the cable through the gland (on both sides)<br>connect conductor with Wago 221-4211<br>push/pull bundle into sleeve (without resistance/if force is needed, something is wrong)<br>attach second cable gland to sleeve<br>tighten cable gland<br>Disassembly/maintenance corresponds to reassembly in reverse order.</p>