Cable Clips

thingiverse

Some cable clips are designed to neatly organize wiring on a 3D printer. Both types are intended to secure flat flex cables between the controller and display board, while the version with a ring also keeps bundled wires tidy. The ring's circumference allows it to accommodate all wires for a direct drive dual extruder carriage. Auto-level sensor wires were not initially considered, but they should fit within the ring as well. The gaps allowing wires to enter are 0.5mm wide, and the O-shaped gap might require sanding to widen it due to its reduced springiness compared to the flat flex cable openings. The "springiness" of the gaps can be decreased by reducing shell thickness - in this case, two shells were used.