Cable Chain for Discovery 200 - Dal addons compliant

thingiverse

English Cable chain path for Discovery 200, Dal enhancement compliant: http://www.thingiverse.com/thing:1200195 http://www.thingiverse.com/thing:1200163 http://www.thingiverse.com/thing:1200492 Chain hinge: http://www.thingiverse.com/thing:11978 As original Dumnac's project other items needed: 13 hinges for vertical chain 18 for horizontal chain 2 end chains 1 start chain 1 open start chain (included) Left chain requires: 13 hinges for short vertical trough (14 for long vertical trough) 1 start chain hinge Other: 6 screws and nuts M3x10mm Update Added new versions: Right chain holder hook Left chain holder v2 Print Settings Printer: Discovery 200 Rafts: No Supports: Yes Resolution: 0.15 - 0.2 Infill: 15% Notes: Mandatory support for part SupportChaineDroit (red part). Optional for other parts. Post-Printing Setup instructions: The left side cable chain can be located on the side of the printer or on the front. Two left troughs are provided: one short and one long (horizontally). The short one is used by default. The cable path on the side of the printer should be composed of the following parts: SupportChaineGaucheVarianteArriere + GoulotteGaucheCourte The cable path on the front of the printer should be composed of the following parts: SupportChaineGaucheVarianteLaterale + GoulotteGaucheLongue Chain support for printing head (SupportChaineTete) has to be screwed on extruder maintaining part using existing screws. Start chain opened hinge has to be attached vertically on right chain holder (SupportChaineDroit). Troughs are to be connected on vertical rods. Be careful while doing so: trough connectors are fragile and might break. Modification of cables: All wires have to be lengthened except X motor ones and, depending on your printer's configuration, inductive sensor ones. Custom Section Update 06/14/2016 There is a mistake with the file SupportChaineTeteFinal.step. It must be mirrored on Y axis.