Cabinet Pull and Knob Templates

cults3d

These are templates to mark where to drill holes for cabinet knobs and pulls. The following items are included: Knob Template: Mark a hole 1 inch in from the edge and 1 inch up from the bottom. Three-Inch Door Template: Locate the center of the door, then mark a hole 1 inch in from the edge and starting 1 inch up from the bottom. Holes should be spaced exactly 3 inches apart on center. Three-Inch Drawer Template: Align the notch to the center of the drawer, then mark holes starting 3 inches down from the top and 3 inches apart. Make sure these marks are centered on the notch. Note: Not all pulls are spaced 3 inches on center, so be sure to check your specific hardware before drilling.