Cabinet Lever Handle/Pet Handle

prusaprinters

<p>A simple lever-knob for cabinets, storage boxes or anything you can find use for it.</p><p>The lever is contructed that you could even train your pet to use it.</p><p>&nbsp;</p><p>It´s made of 3 parts: base, lever and bolt part.</p><p><strong>Base:</strong> &nbsp;print it laying down on the side for robustness after the print. No supports needed but recommend using “Brim” as adhesion on the bed.</p><p><strong>Lever: </strong>the lever should also printed laying down for robustness. One side is flattend, the other rounded. No supports needed.</p><p><strong>Bolt: </strong>print the bolt standing up. Reccomend “Brim” for bed adhesion; also reccomend using the <i>pre sliced bolt-file</i>, since in the <strong>stl.-file</strong> the bolt is slightly angled, which made the print problematic. You can also just adjust it while slicing the file.</p><p>&nbsp;</p><p>The whole construct can easily put together: Lever in the base and then put the bolt trough both. You could use a little bit glue, to glue the bolt to the lever after you put all together, but there´s realy no need for it.</p><p>To mount it, you just need an M4 screw. The hole on the back of the base is 3,6mm in diameter and 5mm deep; an M4 screw will cut a thread in it easily.</p>