Cabinet Drawer Rail Bracket

thingiverse

These brackets kept breaking that hold the drawer rails for our kitchen cabinets. Decided to recreate it as best I could, making walls a little thicker so they hopefully hold up better. Printed in PLA with 100% infill. You can play around with resolution but I used .10mm. Update 03/01/2016 - Printed one of these out last night at .10mm 100% infill. Fit was tight but it went on the rail. What I do is take the rail off, get the bracket started on the end of the rail, then tap on the rail a couple times, test fit, tap some more, test fit. Do this over and over again until you have it seated to the correct length. Works great. With all this being said, you may or may not have the same experience printing them at a lower resolution. It may turn out to be a tighter fit or not fit at all. Print Settings Printer Brand: MakerBot Printer: MakerBot Replicator 1 Rafts: No Supports: No Resolution: .10mm Infill: 100% Notes: Play around with the resolution if you want. I designed this thing around the original bracket.