Cabinet & Drawer Pull + Knob

prusaprinters

The slightly different pull for modern furniture.There are different sizes for US and EU included. (knob follows)For finishing I would recommend the method of HEN3DRIK to give the handles the right finish:https://www.youtube.com/watch?v=MuhlMYTcBywAll credits for the finish go to HEN3DRIK.I haven't had the time to do this myself, and if the method is too time consuming, you can of course use a metalic spray.The picture is a render from fusion 360, but I think they look much better with a real metalic surface.Photos of the prints will followThe following variations are included:-The Knob- US 3" hole distance- US 5" hole distance - EU 96 mm hole distance - EU 126 mm hole distance - EU 160 mm hole distance  There are two mounting options, one version with 3mm holes for wood screws and one with 4mm for threaded inserts.Material: PETG / PLANozzle: 0,4Layer height: 0,16 (works also with 0,2)Infill: 20%Print speed:  50mm/sPrint time: ~7hSupport is required (for an example see the picture)Please note that this model requires post-processing to make it the artwork it was intended to be!Update 06.11.2022:Based on the constructive feedbak that the print layer lines are not quite hidden at the surface and support is required, I added a version for printing without support and rotated 90 degrees. This one does break the design element a bit, but is easier to print. So you can decide what suits you more.