C920 Webcam mount for the Prusa i3 MK3

thingiverse

Logitech C920 WebCam Mounts for Prusa i3 MK3. Four designs have been created, two left and two right, each 80 mm or 120 mm in length. Both lengths function well without issue, having printed and tested four units successfully. This design features a simple slide-on fit that is snugly secure. As this is my first design, I hope it prints well for everyone who uses it. The heated bed has not affected the mount, with only PLA materials used so far; however, higher temperature bed temperatures may alter its performance. The 110 mm version provides a better view of the print bed. This design also accommodates other cameras with a 1/4-20 screw base. Updated: November 7, 2018. Additional mounts were added in response to comments, featuring 85 mm lengths that bend back 90 degrees with 85 mm legs, mounting the camera on the diagonal of the print bed. Updated: October 10, 2018. A new 150 mm right and left extension was added, which should clear updates to the extruder. Please let me know if any issues arise from this update. Updated: June 9, 2018. Two parts were added to raise the camera, one featuring an extended block with a built-in screw, mounted on the right 110 mm bracket. The only issue is that the screw does not tighten completely when facing the desired direction; forcing it may cause the screw to break off. To resolve this, I attach the block to the camera snugly and then attach it to the mount while turning the block to face the camera in the desired direction. Another riser extension features a riser on one end with a 1/4-20 screw hole threaded into the other end. A 1/4-20 X 1/2 inch screw is inserted through the slide-on mount, attached to the extended riser. Then, a 1/4-20 X 1 inch screw is inserted through the block and secured into the camera. Updated: July 10, 2018. A large extension riser was added, utilizing a 2" 1/4-20 screw to attach through the mount into the camera. This design was created after I accidentally damaged the threaded screw on another riser, causing it to snap off. Updated: October 10, 2018. A new 150 mm right and left extension was added, which should clear updates to the extruder. Please let me know if any issues arise from this update.