C64 to SNES controller

thingiverse

This device was made as a controller adapter for Attack of the PETSCII Robots by the 8-Bit Guy. This 3d shell does not fit the adaptor that comes bundled with the game, it is an alternative. I recommend purchasing an original adaptor when they become available from http://www.texelec.com http://www.the8bitguy.com/ https://www.youtube.com/watch?v=6d-B9_iwcl8 Unused pins from the 24 pin edge connector were removed because the connection to the C64 was extremely tight otherwise. 2 mm plastic shims were glued with super glue to the 24 pin edge connector in order to key it to the C64 edge connector. This is to prevent inserting upside down and causing damage to the C64. Pins for the 7 Pin SNES connector should be trimmed to be flush with the bottom edge. ------------ Additional Hardware specifications: 1 piece of 7 Pin connector part Socket Slot for Nintendo for SNES Game Console controller https://www.aliexpress.com/item/32828768824.html 1 piece of 24 Pin Game Card Socket Edge Connector 3.96MM Pitch Female JAMMA Connector https://www.aliexpress.com/item/32821841200.html 2 pieces of 6-32 x 1 inch Socket Screw Cap 2 pieces of 6-32 Hex M/S Nut 2 pieces of 4-40 x 1/2 inch Socket Screw Cap 2 pieces of 4-40 Hex M/S Nut If the LED option is selected it can be connected to +5VDC with the addition of a 300 ohm resistor: 1 piece 234 rectangular LED 3V to 3.2V 20ma 1 piece 300 ohm resistor