C3PO Head Split - Suit "still to come"

thingiverse

I have two and a half incomplete full-size R2D2s, and of course you can't have them without R2's favorite sidekick C3PO. Started the head thus far and will upload more files of the body as time permits. Cheers Jace. 1/06/2017 Just started to print the front of the helmet tonight. No support. Will see how it goes and post some picks soon. I've added the Parts file 1-2-3 early, but could be premature of me. The files look good and should print well, so I'm confident. My printers might print otherwise; fingers crossed. Well, parts 1, 2, & 3 all printed perfectly without the need for support. Each file used 100gms of plastic, which is light too. 2/06/2017 Just going to print 4, 5, & 6 and will see how they turn out tomorrow. Files uploaded now for anyone interested; Cheers Jace. 3/06/2017 4, 5, & 6 printed fine but it was difficult to remove the support from the eyes so I did a second set of eyes Pt4a that worked great. 4/06/2017 Ok, head is complete and all the files worked like a dream, which is always a good start; Starting to split up the chest now; Will be a big job to ensure the most optimized print. Will upload more files soon. 10/06/2017 I've been trying to find references to sizing as I suspect the head is slightly too big. Anyone printing this may want to reduce the head files 5-10%. Cheers Jace. 21/06/2017 Just added the back of the head, thought I had already. Thanks to Psylockybee for pointing that out, Someone's paying attention; Cheers Jace