C3PO Hand and Arm (Sequels Redesign)

thingiverse

*NEW RECENT UPDATES FOR ACCURACY* Most noticeably i remodeled the hand plate to be a little more accurately shaped in the thumb area. The finger parts probably need to scaled up slightly depending on your own hand. You likely will need to make them bigger to allow glove room. The pinky pieces are pretty tiny especially. The arm is a modified version of the Jesse m files, but details have been shifted lower, and/or modified. Ribbed texture is now removed from the wrist of the arm. I removed the top of the bicep for comfort, although your shoulder span could effect whether the top of the bicep will be showing on the costume. So that modification will not work for everyone. I found the main finger parts on thingiverse, but I modified them to be more posable. You may want to sink the middle joints deep into the buildplate in your slicer at an angle to allow more finger posability and resemble the way it was in TFA. Although, that will make them less durable. Parts are typically sized 105% don post/Jesse m scale. Ring finger is optional to have 3 joints or 2 joints. Ep 8 and 9 have 3 joints. In ep 7 it is missing the middle joint. If you go with 2 joints, just disregard the middle piece. Mirror the arm parts, hand piece, and thumb joint to make the left hand. Other parts should work without mirroring. To make 14 smaller palm squares, scale the big square to be around 6mm x 6mm and 1.5mm thick. The palm sections can be made yourself by cutting shapes out of a 1.5mm thick rubber sheet and super glue them onto the inside of the hand. The "New Chest bolt disk" file can be used as the bottom of the elbow bolt. A Chicago screw can sandwich between it with the hole in the disk.