C3nderXY remixed parts

thingiverse

I am using some parts from the C3nderXY project but had to remix a couple. Gantry models without "point 1 extra clearance" will require a tad bit of clearance to fit an eccentric nut in the bottom fastener hole. Both of my ABS versions required me "scratching" the edge with the threads of the fastener. After a couple times the eccentric nut fit snug. I included updated versions with an 8.1mm diameter hole, but I haven't tested myself to see if it is a good fit or not. --General Part Changes-- I fixed the tool head front model so that the top fastener holes do not need to be drilled out, they will print like they are supposed to. I plan to also fix the "z bed 12mm rod" model that has the rod path obstructed. In the meantime, you can mirror the "z bed 12mm rod-L" model so that it can be used on the opposite side. --Custom Part Changes-- These changes may not be useful to you, but I will detail them here. -HOT END SHROUD CHANGES- Patterned, Generic Cutout, and No Pattern -I found the original hot end shroud to be lacking for my personal needs. There was no way to mount the original part cooling fan or a BL/CRtouch sensor. Currently this shroud does not have those built-in, rather they are a separate model. It is intended that if you want the sensor mount/part cooling fan mount, you print those and mount them using the lower left/upper right shroud fasteners. -This remixed version allows the heater and thermistor wires to be routed into the shroud, not around. Also, it has significantly more clearance around the top of the heat brake. -I experimented with a pattern cutout on the sides, not sure how I like it so there will be a patterned, non-patterned, and generic grill style versions available. -The Sensor mount is slotted to allow for minor adjustments of the sensor location. This may be useful to set a precise sensor offset. -The part cooling fan mount may end up with a slotted version to allow for adjustment up and down. For example, if your nozzle position is higher or lower relative to the stock part cooling fan, you can adjust it up or down to blow right on the printing area. For now this seems okay, I haven't gotten to test it just yet, but the CAD assembly example and real life model seems to be fine. -GANTRY CHANGES- I am using a 20x40 extrusion on the top where the gantry rollers are. The original design was 20x20, so this had to be changed. The gantry mounts in this remix are sized to fit on a 20x40 piece of extrusion (with the extrusion oriented 20mm horizontally and 40mm vertically). -TOOL HEAD CHANGES- I have increased the cutout indent for the top two FRONT tool head fasteners. This will allow larger head fasteners to not protrude towards the hotend, as well as allow shorter fasteners to be used. I increased the hole diameter of the bottom fastener to allow an eccentric nut to fit. The original model did not allow an eccentric nut, at least the one from my stock ender 3 clone, to fit. I decreased the thickness of the rear tool head without changing anything else. This should also allow a shorter length fastener to be used. Honestly, the original one was fine but my 40mm fasteners are a bit short using the original models. I plan to upload any other parts I modify here, let me know if there are any specific parts you would like redone.