c270 Prusa Mk3 Camera mount solid bed mount

thingiverse

The C270 camera mount is secured to the camera via its own hinge pin. A dual-diameter bolt fits through the sliding mount, enabling easy attachment and detachment. To remove the original weighted Logitech mount from the camera, use a thin knife to carefully pry off the covers over the ends of the hinge pin. This will allow you to utilize a screwdriver to remove the pin. If necessary, apply gentle pressure with a thin screwdriver or similar tool to push the pin out. The printed camera mount should be loose on the hinge at this point. Next, insert a small metal washer (M3) onto one end of the hinge pin and a tiny rubber washer on the other end. This will provide stability and prevent damage to the camera's components. When printing the bed mount, it is essential to use either ABS or PETG filament as it will be in contact with the build plate. PLA filament may not be suitable for this part due to its properties, but it can be used for the other parts without any issues. The Solid End Bed Mount is designed to fit snugly around both the bed frame and heat plate spacer. To ensure a proper fit, you may need to scale the part according to your specific filament and annealing process. Placing the bed spacer in the part while it is still hot can make assembly easier than waiting for it to cool down. Assemble the bed mount with minimal force, using only a small amount of pressure if necessary. If you find that more force is required, either scale the part and reprint or use a file or sandpaper to create additional clearance. On July 30th, 2018, an updated version was added, extending the length by 20mm for better compatibility with various camera mounts.