Bytech 3-Port USB Charger Loft, Bunk or Rail Mount

thingiverse

A simple bracket to mount an older Bytech 3-port USB charger to a loft bed to hold the charge off the floor and closer to the desk (or lower bed for a bunk) or upper bed. This is designed to slide over a square rail or board that is 40mm tall and 20mm thick. The base of the charger is removed and then screwed to the bracket. The base is keyed so the charger will only fit in one orientation. The 40mm version extends the full 40mm on both sides, while the 18mm has a short side opposite the charger. The shorter version was needed to make room for an LED strip. Print in the default orientation (as pictured) without supports. The underside of the mounting hole may need a few strands removed because of an overhangs and lack of support, but it is an easier cleanup than generated supports. A 45 degree chamfer would fix this, but it works as-is so I left it.