Butterfly lamp shade 3D print model

cgtrader

Butterfly lampshade! I design it for E27 with dimensions 135x135mm and a hole of 42mm to fix onto any type of lamp. For quick and efficient production, I highly recommend using a nozzle of 0.8mm - the thickness of the piece itself will be about 1.6mm, saving you hours in work! A standard print can take around 14 hours, but with my design, it's cut down to just five hours. Be cautious, though; the printing is relatively simple, but make sure to handle each butterfly carefully when removing its antenna brackets (refer to the attached photo for guidance). Cutting these with a blade heated by lighter should be your first step, and all other supports can simply be taken out using pliers. For an ideal print: Use either a 0.8mm or 0.4 head Opt for no support whatsoever Choose a layer height of just 0.2 mm Increase infill to 100% Run the printing speed at 40mm/s Lastly, remember to adjust your Z hop value to 0.60. Don't forget, a perfectly done print with this configuration will leave you amazed! May my butterfly design light up your workspace!