Business Card Boomerang - VASE MODE

prusaprinters

Whenever I got promotional cards, business cards, or even just a useless deck of cards lying around, I would always turn them into tiny boomerangs. But the problem I always had was always how quickly they would deform after a few throws, which is why I decided to turn it into a 3D print.It takes a while to get the hang of the angle and flicking action to get it right, but I'm sure you can get it as I did.  CAUTION: The edges are sharp so make sure to file them a little before handing them to kids.     'UPDATE: A little tutorial on how to throw this You're essentially trying to flick it around your middle finger by pulling the back edge with your thumb while applying some pressure forward with your index finger.The video below is how it should look when you release it.Then once you get the flicking action down, just try doing it faster to get more rotations along with angling it against the direction of your throw so that it'll glide back down toward you.Hope this helps!'