Burris Scope Throw Lever (40mm)

prusaprinters

I recently purchased a Burris droptine rimfire scope and found that the magnification ring was extremely hard to turn. Decided to Design my own throw lever rather than pay $30 and get one that only hopefully works. Uses an M2 nut which is inserted with the printer paused and a 12mm M2 hex socket cap screw. Can only guarantee it will fit on the specific model listed but it may work on other scopes with 40mm magnification rings. Recommended to print with no supports, 100% density, and at least 3 walls. Make sure to add a pause so that you can add the M2 nut before the pocket closes.