Bureau of Balance Bracer - The Adventure Zone

thingiverse

A simple Bureau of Balance bracer I designed. Prints as a flat sheet, photos show it finished with filling and sanding primer, wet sanded, and Rustoleum 2x Metallic Silver spray paint. Use a heat gun or hair dryer to warm the unpainted side until flexible, wrap around your wrist, and run or spray water over it to make it hold the shape. The narrow end goes toward your hand. I prefer 40% infill, lower may show the infill pattern once bent, higher makes the shaping take longer. If you have a large arm, consider adding slots in the ends that allow for lacing or elastic threading, although I haven't found this necessary except for very large arms. Alternatively, simply print it larger so it wraps around comfortably. Available for purchase at: https://www.etsy.com/listing/684511570/bureau-of-balance-bracer-rigid-3d-custom