Bunny Filament Clip [BF Clip]

prusaprinters

BF Clip The BF clip gives you the convenience of a float-on-spool design but with more flexibility. It can be easily attached and removed from the spool, even while printing. The ears and the feet have been designed to clip onto a 1.75mm filament. Notes: All printers are calibrated differently. This file has been designed with tight tolerances, if you run into a fitment issue try scaling the model on the X&Y axis (if you have a larger filament you might be able to do this as well. Make sure to comment on the setting to help others out) in your slicer. If you have any elephant's foot on you're print it will help to print with a raft.  PLA [My Print Settings]:Nozzle = 0.4mmLayer height = 0.20mm Build plate adhesion = Raft Walls = 2Infill = Shouldn't matter too muchHow To / Features:What do I do with it?? Honestly, that is up to you…you could take it out for a date or hang it in your window… but I would recommend putting it on your filament spools. You can either put the end of the filament through the hole and push the clip around until the end meets up with the BF clip, or you can just clip it on the filament and then to the end of the filament. What's “ float-on-spool design”? Instead of having to take your clips off the filament and lose them, you can just push the filament into the middle of the clip and let it float on the spool. Why a Bunny? Well much like our furry little friends, these clips can hop away when there is danger. The danger, in this case, is if the clip gets caught on filament during a print. Instead of adding undesired tension to the filament and causing a potential print issue.