Bunny Base for Rabbit Pulling Carrot Doorstop

thingiverse

Our rabbit was just a bit too short for the gap under our door, and PLA slides easily on tile. So we gave her a little base to lift her up and give her more traction. These parts are based on the [Bunny Rabbit Pulling Carrot Doorstop](https://www.thingiverse.com/thing:3475755) model by [CaptObvious](https://www.thingiverse.com/CaptObvious). This is printed in Flexfill 98a. With 0.2mm layers and a 0.6mm nozzle, it took about three hours to print. Flexible materials print very slowly. Super glue seems to be holding everything together well so far. I clamped it in a [(printed) vise](https://www.thingiverse.com/thing:2064269) while it set. This STL file is 10mm tall, which should be more than enough for most door gaps. The photos show a 5mm printed height. There's plenty of [software](http://www.meshmixer.com/) out there that can do a basic plane cut so you can choose the exact height you need without needing any complicated software. Your slicer may even have a plane cut feature.