Bungee Clips for tarps

pinshape

I have a great little trailer that I use to haul everything, and the problem is that the eyelets on the tarps don't line up with the tie-downs on the trailer to allow the tarp to pull tight and/or straight. The solution I came up with is as follows: A small hole is the bungee hook hole. The 'disco ball' gets wrapped in the tarp, then pushed through the large hole and pulled through far. The tarp is then slid along the keyhole section and pulled tight; the disco ball disallows the tarp from pulling through and allows you to attach the bungee at any point on the tarp. If you put the disco ball on the inside of the tarp, it allows the bungee to also hold the tarp ends down a little thereby reducing some of the flapping in the wind. This is not designed to be used on the same spot on the trap over and over. If you have the tarp on the trailer or load for a long time, make sure you check the wear on the tarp and/or move locations on the tarp to make sure you don't rip through. The hole in the disco ball is to allow you to tie it to a location on the trailer so you know where it is at any time. I will have pics of how I have mine set up soon.