Bumper light bar for RGT Rescuer / FTX Outback Tracker

prusaprinters

There is a small panel hiding a spot for a light bar in the front bumper.It is held in place by a few small plastic pegs that are easy to cut.The inside of the bumper has 4 screw holes. 4x M3x8 screws should be more than enough to keep the light bar in place.  You will need to install 5 LEDs in the light bar yourself, don't forget the current limiting resistors.You can get power from them from the receiver, it has a free channel, or use a Y splitter on a used channel.Original orientation prints with supports. Can be printed on it's side without supports if your printer can bridge a 50mm gap.A small clip is included to keep 5MM LEDs in place in the existing light pockets in the front and rear bumper, mounts with a short M2 screw.