Bullseye CR Touch Mount Ender 3 Left

thingiverse

Bullseye Duct System CR Touch Mount for the Ender 3 Pro. Left Side Mount. First and foremost I want to start with a **WARNING:** While this does work for the Ender 3 Pro It will require a little bit of trimming of the plastic around one side of the mounting support on the CR Touch. The tolerance and clearance are very tight The original design didn't allow for a flush mount of the CR Touch. The CR touch was pushed up against the duct of the bullseye causing misalignment of the bracket and the CR Touch. I flipped the orientation to allow more clearance between the duct and the CR Touch, made the mounting plate 5mm lower, and tightened up the screw holes for the m3 screws so you no longer need additional hardware. Just directly thread the M3 screws into the bracket. Offset should remain the same X-48 Y-10. For me this is the exact position of the original Creality mounting plate for the CR Touch and the reason why I didn't change the angle to allow more clearance for the mounting hole and the CR Touch. All credit for the original goes to https://www.thingiverse.com/thing:2759439 and https://www.thingiverse.com/thing:4978929 for the remix this was mixed from.