Bullet and Square Pixel Pusher

thingiverse

IMPORTANT – IF USING “DOWNLOAD ALL FILES” – THE DOWNLOAD WILL INCLUDE THE WRONG RECEIVER FILE. THIS IS AN ERROR WITH THINGIVERSE I CANNOT FIX. YOU WILL NEED TO DOWNLOAD THE FIXED RECEIVER FILE INDIVIDUALLY. SORRY FOR THE INCONVENIENCE. November 12, 2021 Fixed error in the Base Receiver found by Steve758, Thank you for the catch. July 15, 2021 REVISED.... The original design was removed and replaced with the new Base and Receiver. The new Base tower is wider and and has two pre-made holes. This will give more strength and avoid breaking. Also, the two holes can be used to install two 2 inch screws if needed for extra strength. The pixel Receiver has been separated from the base. It will need to be installed using four 3/4 inch screws. This has been done to make it easier to redesign and reprint the receiver as needed. The receiver has also been lowered due to pixels received in 2021 being inconsistent in height, only 1mm to 2mm but, this caused an issue in pushing the pixel all the way through. Project for Pixel Pusher used with bullet or square pixels. I wanted a pixel pusher that could be used without a drill press but worked similar to a drill press. This design allows users to have a bullet and square press pixel pusher that can be made with a hand drill. No drill press needed. © 2021. This work is licensed under a CC BY NC4.0 license. Print Settings Resolution: 0.3 Infill: 75% Wall Line Count 9 Top and Bottom Layers 9 Rafts on Pusher Jig and Square Jig Supports needed on drill jig large holes only Parts needed four - 3/4 inch screws (like kind you use in a wood fence) two - 2 inch screws (like kind you use in a wood fence) one -1/2 inch electrical metal conduit pipe 14 to 18 inches long, one -1/4 inch bolt 2 inch long. one -1/4 inch bolt 2 1/2 inch long. two - 1/4 inch nuts for bolts one spring device of choosing. I used a metal binder clip attached with zip ties. 1/4 inch drill bit March 31, 2021 Revised Base and Drill Guide added. Hole enlarged in drill guide for inserting pipe. Outside edge of square jig slot thickened to add strength to jig slot. NOTE: It is important to print with Wall Line Count 9 and Top and Bottom Layers 9. Also, it is very important the holes in the pipe are square to the base. VIDEO: https://vimeo.com/manage/videos/540879991