Bulldog XL++ v1.1 (remix)

thingiverse

I remixed the Bulldog XL despaghettification accessory by Klaverentwee, and I'm grateful to him for sharing this work with me. Unfortunately, it didn't fit my early version original BulldogXL extruder perfectly. Two feeding screws extend approximately 3mm towards the driving gear, so I had to make some modifications to the design on both sides. The picture shows how I modified the design in comparison to the original one. It works fine for me except for the 1.8mm drilling it required after printing. I suspect that it needs to be printed at a slower speed or with more cooling than I can provide. I hope this remix is helpful to someone else. If you have any questions about the design, please leave a comment below. Thanks, Sascha