Build Your Own BAN HAMMER

thingiverse

Create a BAN HAMMER desk accessory using TinkerCad, as no similar designs were found on Thingiverse. The design consists of three parts: the hammerhead, featuring "BAN" on both sides and a bottom slot for the handle; the handle-section with connectors on both ends (print two); and the handle-base with one connector end. After printing, it was noted that the connectors were too large, so the designer revised the handle section and base to have smaller male connectors. A "v2" version of the files is available. Only one handle-section part is needed, as two would result in an overly long handle. The tight fit may cause connectors to break; increasing the hammerhead's size is planned for future updates. To assemble, print the hammerhead and handle-base, and two handle-sections, which should connect securely. Superglue can be used for extra stability.