Build-A-Bong: MiddleTreePerk(MTP)

thingiverse

This is a final product of the "Middle Tree Perk Build-A-Bong - Proof Of Concept". This marks the beginning of many 3D printed Build-a-Bongs to come. My main goal was to fine-tune the sizing so that there would be minimal air loss, if not zero. If you're aiming for zero air loss, I recommend using a 0.1 height layer and slowing your print speed to 40 mm/s - essentially printing in high quality or equivalent to your printer's capabilities. I've tested this design and it works perfectly. I printed mine at a height of 120 mm. To improve adhesion to the build plate, especially for those without heated build plates, I moved the tree perk to the bottom of the tube. Since you can't see through plastic, there's no need for aesthetics. Print Settings: Printer: MOD-t Rafts: No Supports: No Resolution: 0.1 mm Infill: 25% Notes: For absolute zero air loss, try doing 100% infill! I haven't tried 0.2 m with 100% infill yet, but I'll update when I get around to it. Post-Printing: It sits snugly inside and even works with K-clips!