Bugaboo Buffalo Standboard adapter Full version and Half (for smaller print beds)

thingiverse

I bought a Bugaboo stand board in a secondhand store and when i got home it didn't fit on our Bugaboo Buffalo Stroller with out an adapter. I looked up the original adapter model which consists of a openable case model which one needs screw so tighten on. The original model is injection molded and was designed with that in mind. My "half" version is designed to bee printed with the cylinder part upwards and will not need support, and it didn't need support when i printed it. Print two half's then use a knife to detach potential micro stringing between in each half's split. Then the PLA plastic should be flexible enough to open up and snap around the bar between the wheels on the Bugaboo Buffalo, at least it was for me. once both half's are snapped on you can use screws to lock them on or some tape around the cylinders. Once the board is snapped on it should all sit tight and nice. the version i printed dident need any screws. And if you have, I strongly recommend attaching reflective tape to the adapter. High visibility save lives in traffic! If you print one please show us! :D Best regards from an engineering dad.