Bucket Hat

myminifactory

Bucket Hat, that should be printed in VASE MODE (In Cura: Spiralize Outer Contour, Underneth Special Modes) Print bed must atleast be 255mm, 255mm, 145mm and should only take around 8 hours to print. The hat is  This hat was printed in PLA, with normal settings; however tweaking settings might be needed to get a good result. Each layer is really thin, so make sure to be careful; however the hat is actually really flexible. The bucket hat should be printed upside down. There is also a version that is 1/4 of the size of the hat.