BTT Filament Sensor Mount BMG v2.0 on Ender 3 V2

thingiverse

I did not see any mounts for the Ender 3 V2 with a Trianglelab BMG V2.0 I decided to make it two pieces so I could print them in the orientation I wanted and without a ton of supports. Print in the orientation from Cura pictures. I used an overhang angle of 50 and for part 2 I used a support blocker for the screw holes so I did not have to hassle getting the support stuff out. It requires two M3 x 8mm screws to attach the pieces together. You can go a little longer or shorter I just had 8mm once laying around. The dimensions fit my BTT Sensor but were slightly larger than the spec they showed. So it seems these sensors may vary in size a little. Just FYI I also included a one piece design incase you do not want to screw them together. I have not printed it that way and supports would be needed.