BTS7960 43A High Power H Bridge Module

grabcad

BTS7960 43A High Power H Bridge Module Supply Voltage: 5.5V to 27V, 43 A https://bit.ly/2XbuiSp The best thing about this driver is its ability to control motor direction with just four pins on the Arduino: L_EN, R_EN, LPWM, and RPWM. I don't need to connect it to the 5-volt and ground connections to get it working properly, unlike the DROK L298 dual H-bridge driver that requires a connection to the ground pin of the Arduino to function correctly. It is more efficient than the DROK L298 dual H-bridge driver, with less or no voltage drop, and supports up to 43 amps. BTS7960B H-bridge 43A high-power motor driver Module Overview: This driver uses Infineon chips BTS7960 composed of high-power drive full H-bridge driver modules with thermal over-current protection. Double BTS7960 H-bridge driver circuits are strong, with effective braking and isolation from the microcontroller and motor driver! High-current 43 A Features: * Double BTS7960 large current (43 A) H bridge drivers * 5V isolation with MCU, effectively protecting MCU * 5V power indicator on board * Voltage indication of motor driver output end * Can solder heat sink * Just four lines from MCU to driver module: GND, 5V, PWM1, and PWM2 * Isolation chip 5 V power supply (can share with MCU 5 V) * SIZE: 4 * 5 * 1.2 cm * Two PWM input frequencies up to 25kHZ * Two heat flow passing through an error signal output * Supply voltage: 5.5V to 27V