BTE13-001 Voltage Regulator Case

thingiverse

Great original box. Unfortunately I had to forcefully wedge my module into the box and after doing so, the power in/out plugs wouldn't fit in because the cutouts were too small. I definitely have the same module board and because of component placement I couldn't sand the module's PCB down slightly smaller either so I'm not entirely sure how the original poster was able to get his to work out. Anyway, I increased the size by 3% (both the bottom and the top, so you'll need both) which allows the board to easily fit in with almost no play once the top is secured without screws...with screws it holds perfect. I also reset all the side openings so they are aligned and of proper size/clearance. Also for the DC Power Plug opening, I changed it from a square of the whole component to just a circle that easily allows the plug to fit into it. On the supports...I did print the bottom box with supports only because the first print of the original I didn't and I had just a tiny wisp on the first layer that bridged over the openings in the sides. Since this is 3% larger, I thought it could only get worse (but still, probably only on the first couple bridged layers). Anyway, you can probably get away without support on the bottom depending on how well you want your openings (or how optimized you have your bridge settings setup).