Brushless Whoop

thingiverse

Now with transport box Uploaded a lighter, stronger aerodynamic frame and some prop guards for it Print the prop guards in nylon The older version of the frame has too much surface area, resulting in minimal lift Plan to build a 1s brushless Whoop with a 58mm diameter and 1102, 10,000kv motors, paired with the TinyFish combo Visit boldclash.com for information on the BoldClash Fish01 F3 Flight Controller 1s 4a BLHeli-S ESC Tower Print the blue absorber for the 16x16 FC in flex material Motor specifications: 1102, 10,000kv Props: Gemfan 2035 cut down to 38mm in diameter Battery: Lipo 1s 210-250mah with a PowerWhoop connector Expected flight times are around 2:30 to 3:00 minutes Hardware requirements include four M2x12 screws and four M3 nylon screws, cut down for the flex absorber Use only two screws per motor To access the cable, unscrew the motor next to the USB port The CamHolder is from FishPepper, thank you In BetaFlight board sensor alignment, yaw is set at 45 degrees Resource the motor if necessary in CLI dump