Brother KH910 Knitting Machine AYAB conversion cover tray

thingiverse

Please show your gratitude by Tipping, as it goes towards materials used in the design process. Thank you This design is for the Brother KH910 electronic knitting machine that has been updated to AYAB electronics. This tray cover is to replace the cover for the mylar sheet mechanism. Remove the original cover, unplug the mylar sheet mechanism and unscrew from the knitting machine. Install your newly printed tray and take the original mylar sheet over and cut to size in order to close the gap left on the machine. Dont cut too short. Please refer to the attached photos. Install the cut piece and screw the new tool tray down using the original screw. You may need to push hard against the new tool tray and cut cover in order to locate the screw into the screw hole. This is so that the cut piece from the original cover remains in place. I used white filament however prefer grey filament, as it compliments the rest of the machine colour. It is a slow standard speed print which takes 18h30 and uses around 67meters of filament Future plans is to make a cover to store the tools for when packing the machine away.