Brondell Swash 1400 Remote Hang Mount

prusaprinters

I didn't like any of the options to wall mount the remote control for my Brondell Swash 1400 bidet seat's remote control. I considered designing a shelf, but decided my best option would be just to hang it. To facilitate hanging it, I made a simple backplate for the remote mount. I attached with two M3x6 screws and associates M3 nuts. Print in provided orientation (flat side down). You shouldn't need supports. Designed parametrically in Fusion 360. Fusion 360 export included in downloads. I included both 3MF and STL mesh files. These should be equivalent, pick the one you like. Don't over-tighten. A small washer might be a good idea. Print Settings Printer Brand: Prusa Printer: i3 MK3 Rafts: No Supports: No Resolution: 0.3mm Infill: Default for Prusa Slicer Filament: Hatchbox PETG White Notes: This should print fine in pretty much any filament. I had white Hatchbox PETG loaded, so that is what I used. I provided a small amount of tolerance for the screw holes and nut inset. You might find these a bit tight, but I think it will be OK for most people. I printed at 0.3mm as I didn't feel the extra resolution was necessary. I don't think supports should be necessary. If the edges are too rough, you could certainly sand the piece. The texture doesn't bother me. How I Designed This Category: Bathroom