Briss Fang Fan Covers and WS2812 Holders

thingiverse

What is the Briss Fang fan shroud? Plenty of YouTube on it but basically a very well designed shroud that gets the fans to the outside with much more and even airflow. You will need to pay a dollar something for it and well worth it. Why the fan covers? While I really do like the Noctua fans, they do not come in any color other than beige/brown. Wanted a minimal cover to change the color keep my fingers out and came up with these. There is only a single varient of the top cover but the front cover has a plain one and three WS2812 versions to have dual (as pictured) or a single left or right WS2812. They all use 20mm long M3 screws, and all 4 positions are supported on each fan (ran short 2 screws and will update the photo). When using one of the WS2812 versions print the Briss Fang without LED mounts (not room for both). The WS2812's are mounted on round PCBs about 9mm in diameter and are available from several sources already assembled but you will have to do the wiring between them and back to your controller of choice. The mounts have a small hole for a piece of filament to push behind the PCB to hold it in place. See picture and do trim them back. The printing process will probably leave the hole rough so plan on using something to get it back to 1.75mm. See https://www.thingiverse.com/thing:5390581 for my CR Touch mount remix for the Voxelab Aquila X2 that works with the Briss Fang as seen in the photo.