Brinckers Brisbane E-Bike fender

thingiverse

The fender of the backwheel is not long enough to prevent water and dirt to be thrown up so it ends up in your neck or on your head. Brinckers has acknowledge this and made a rubber flap that is ugly and I also wonder if it is long enough to prevent the water and dirt from landing on my head. I therefore developed and printed a better solution. Remove the original fender by pulling the lip from the side of the wheel and pull the fender off. Slide the printed fender on and use 1 or 2 screws to fasten it by drilling a hole somewhere at the top. In the pictures you will see the solution of the manufacturer and the printed solution. To complete it, I also made a fender for the front wheel. Print with an infil of 60%. When printing strait up no support is needed.