BRH v2 - Basic Roll Holder

thingiverse

This is version 2 of my BRH - Basic Roll Holder. ### Improvements - Thicker dual wheel prongs handle heavier loads more effectively than thicker quad prongs. - A reduced amount of material in the panel body and wheels cuts print time by one-fifth when using a cura profile. Still refining ideas for further improvement; this version should be compatible with v1. ### Requirements for This Print - No bearings are needed. - There is no need for supports. Print the panel with the prongs facing upwards on the bed, and the wheels either flat side down. If worried about warping, use a large brim.