Breville SHM2 mixer knob

prusaprinters

<p>New rotary switch handle for mixer base rotation speed for Breville SHM2 mixer.</p> <p>The factory one is too small and impossible to turn if you hands are slippery (like when you are baking!).</p> <p>This design is a granny-proof sized knob that is a direct replacement. The old knob pulls off with the help of a knife/screwdriver and this one just pushes in place until seated flush.</p> <p>There is a spring-steel clip helping retain the factory knob, but this print is a firm push-fit so doesn't need it.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>I3 MK3S</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>0.15mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>on sheet only</p></div> <p><strong>Filament:</strong> Prusament Galaxy PLA Grey</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Printed at 0.15mm layer height, 3 perimeter vertical shells, 10% gyroid infill (not critical).<br/> Print handle-up to get the best surface finish, so the support material is on the inside only. <p>Support on build plate only (supports should fit within the base footprint)</p> <h3>Post-Printing</h3> <p><strong>A bit of scraping needed to get the support out of the hole for the shaft, but can be done with a pair of needlenose pliers or drillbit.</strong></p> </p></div></p></p></p> Category: Parts