Breadboard Mount

thingiverse

This is just a mount for breadboards that are easily found at most electronics stores . I based my design on "sceadu_design" of an Arduino Board Holder. I visited the link at thingiverse.com to find more details:http://www.thingiverse.com/thing:33327 My goal was to create a breadboard holder in a similar style. Here are the print settings I used: Printer: I used a Davinci 2.0A for printing Rafts: No raft support needed for this project Supports: I chose not to use supports in my print job Resolution: The print resolution was set at 0.3mm My Notes: When using 0.3mm resolution on this board, the snug fit worked perfectly with a little light sanding . Even better results would be possible by adding screws for even tighter support if needed .