Bravetti Preimum Pro, Deep Fryer basket - HANDLE

thingiverse

Print two identical halves. Remove the old melted handle from your fryer basket. Heat the metal loop with a torch or over a burner, apply super glue to one half of the new 3D handle. Press the two halves quickly onto the hot metal and clamp until the glue sets. The hot metal will melt your print slightly and stick firmly in place. The glue helps. This is to replace a fryer basket handle that may have melted inside the fryer. Don't ask me how I know they can melt, or why I took the time to model a replacement... In my case, the loop of metal wire going inside the plastic handle was not an exact fit for the 3D model. My 3D model is mathematically precise, but I think the metal wire bending at the factory is not a perfectly round radius. Hence heat it up a bit and it should melt right into the groove of the 3D printed part.