bracket for thing 1118084 (Sonicare bracket) and Delta 75056 holder

thingiverse

Bracket to attach a Sonicare next to an existing Delta 75056 tumbler/toothbrush holder, using Endar's excellent wall mount bracket. In these pictures, this thing is the white part that sits flat against the wall. You will need: This part Endar's bracket (https://www.thingiverse.com/thing:1118084) 2x M3-10mm socket head cap screws 2x M3 hex nuts 2x M3 washers It might be possible to use other M3 screws. The holes on Endar's bracket are tapered to accept countersunk screws, but I don't know if there is enough material there to hold securely without a washer. It is a good idea to do a test fitting before attaching it to your wall, particularly if you are using different screws. If your screws are too long, they will poke out the back and might damage your wall surface. Installation Instructions: Use the screws and washers to draw the hex nuts into the pockets on the back. Tighten them completely to ensure that the nuts are fully seated. Remove the screws. Loosen the setscrew on the bottom of the Delta fixture and remove it from the wall bracket. Remove the two screws holding the bracket to the wall. Place this thing behind the bracket and re-install the screws. Leave it just slightly loose at first and test the fit. Tighten the screws when everything is centered. Re-attach the Delta fixture and tighten the setscrew. Insert the two screws, with washers, through Endar's bracket and into the holes on this thing. Tighten. Route your cable through, and slip the Sonicare base into place.