Boîte à tours - Challenge techno (Prankster box)

myminifactory

This case was designed for a challenge completed during Techno Challenge Day. (https://www.challengetechno.com/. ) Participants must complete the circuit inside the case. Unfortunately, we cannot publish the circuit that goes with the box since it is part of the challenge. The case was originally printed with a Stratasys printer. It was necessary to make adjustments before arriving at a good impression with Prusa I3MK3 printers. Below are a description of modifications made. For the bottom case and clip: -The lettering has been engraved instead of coming out of the box. If the lettering "comes out" of the box, printing must be done on support material, giving bad results. The bottom case was printed with support material. - The clip is not perfect and is a bit hard to get out but I did not have enough time to make changes. NOTE: The bottom case has been printed with support material. For the top case: -The grid of the mouth was too small, giving bad results. (see the.zip) It has been enlarged to achieve a nice finish. - The maintenance of the speaker and piezo which had been drawn for the Stratasys did not work with the Prusa. These were designed as cases in which we could insert the speaker or the piezo and then screw them in place (see the zip). With the Prusa, support material was too difficult to remove and broke the case. The speakers' case has been modified as shown in the photo. NOTE: The top housing has been printed without support material.