Box Mod Dual 18650 & Mosftet (Cloud Chasing)

thingiverse

The dimensions of this enclosure measure: 56x25x88 mm. Consider printing it with ABS because PLA may not withstand this type of usage. To assemble the enclosure, you will need: * Ten magnets measuring 3x1 mm * An on/off switch (available at http://fave.co/2boIKAN) * A 12 mm push button * A mosfet IRLB3034 (accessible at http://fave.co/2bsiYPl) * Battery contacts (your choice, with up to 74 mm of space available) For the wiring, refer to the scheme displayed in the photos. This enclosure is designed for two 18650 batteries connected in series, not parallel. Underneath the mosfet lies a small piece of cork, ensuring it does not make direct contact with the plastic. Choose from: * Two distinct connector holes (10 and 12 mm) * Two different door options: one with direct access to the on/off switch, the other without Remember, for your safety's sake, to power off the enclosure when you're done using it. The printed enclosure featured in the photos was created using a Zortrax M200 at 140 microns.