BOX for NVR board NBD8009S-ULA 9CH*5MP

thingiverse

This is box for NVR board NBD8009S-ULA (slim version, first revision). I bought this board from this seller http://ali.pub/554qv7 I decided to design a case with the ability to install a 2.5-inch hard drive. The body consists of 4 parts, which are printed separately: main box, back panel, top cover, stands. Printing is done with PLA without supports, preferably on borosilicate glass to avoid shrinkage or warping. The rear panel with the “smaller version” mark has a 0.5 mm less edge width and 0.3 mm less height. Should snap into place without further adjustment. I recommend this version for 3D printing. The back panel is glued to the body, for example with a hot glue gun. Also requires 6 custom M3 screws and 2 nuts. For fixing the main board, 2 screws and nuts, and for the hard disk, 4 screws. The case has several disadvantages: - the lid may not completely adhere to the body and does not hold tightly; - the walls of the case are not thick enough and the light from the LED on the board will be visible. I was pleased with the end result and was too lazy to make any changes. All Solidworks CAD files (sldprt) are included. I'm not a professional designer and the model's drawings are pretty sloppy.